Functional Safety Expert Training
You will have the ability to set up process control and safety systems, perform system validation, use risk graphs, and perform SIL analysis.
Purpose of the Program
Participants should have a thorough knowledge of the functional safety lifecycle, Process Hazard Analysis (PHA), Results Analysis, Layer of Protection Analysis (LOPA), Safety Integrity Level (SIL) Target Identification, Safety Requirements Specification (SRS) device and system reliability, SIF verification, SIF design, and business requirements.
Output Program
At the end of the program, participants will have the ability to set up process control and safety systems, perform system validation, use risk graphs, and perform SIL analysis according to IEC 61508 Series and IEC 61511: 2016 Series Standards.
Who can participate in the Program?
Process Safety Engineers, Reliability Engineers, Engineers / Business Managers, Maintenance Managers, Occupational Safety Specialist, Electrical / Mechanical Engineers and Technicians.
Learning Content
Introduction to Safety Instrument Systems (SIS),
Principles of Risk Management (ISO 31000),
Safety Life Cycle,
Process Hazard Analysis (PHA),
Results Analysis,
Probability Analysis,
Layer of Protection Analysis (LOPA),
Commensurable Risk Level,
SIL Analysis and Target Level Selection,
The Safety Requirements Specification (SRS)
Safety Instrument Systems (SIS) malfunction,
The transition from failure rate to SIL,
Single devices in the system,
Redundant Architecture,
SIF Installation requirements,
SIF Design and Verification in Safety Life,
SIF Detail Design,
Operations.
